AT-320 H323 Phone User Manual (V1.39)
5
¾
Installation:
1
Connect handset to base: insert handset cord into handset cord jack at the left side
of the base.
2
Connect IP phone to Internet: plug the RJ-45 Ethernet cable into the Ethernet Jack.
Plug the other end of the cable into HUB. Refer to Fig 2.2 please.
Power on IP phone: p
lug the power cord adapter into the Power Jack. Then plug the
other end of the power cord adapter into the appropriate wall outlet.
¾
Configuration
Four different ways can be used to configure AT-320 H323 phone: phone
keypad, web browser, Telnet commands and PalmTool configuration tool on
computer.
¾
Phone Keypad setup
●
Function Keys Introduction:
When using keypad and LCD to configure the
settings of IP phone, following keys will be used:
Keys Function Keys
Function
LOCIP/SET
Enter setting mode
SPEAKER/OK
Enter submenu; confirm change
VOL
Turn over menu
backward
VOL -
Turn over menu forward; move
cursor backward
NUMBERS
Modify values
REDIAL/EXIT
Exit current menu; exit setting mode
●
Enter into settings
Please Inputting the phone password on the keypad (
I
f the debug
isn’t 0,the original password is 1234; If the debug is O, please use super password
1234567878)
then press # for a while until there is Password stated on the
LCD , Please input the phone password again and press to
confirm. You successfully enter into settings.
Password
#