LPX-1000 Scanner System
User Manual
Section 2
Copyright © 2008-2012 ATCO. All Rights Reserved.
850-004134
Page 11
Revision A.0
Keep Clear of
Debris and Dirt
Y Axis Top View
Y Axis End View
Figure 21
Y Axis
Keep Clear of
Debris and Dirt
Y Axis Top View
Y Axis End View
Figure 22
Y Axis
General Maintenance of the Y Axis
The Y Axis should be inspected
prior to use. Inspect the rail where
the slide bearings make contact
with the arm (shown right) to
remove any loose debris or dirt.
Y Axis Drive Belt Tension
The Y Axis drive belt must be secure, but not overtightened. There should be minimal play in the transducer slide
block.
General Maintenance of the Y Axis
The Y Axis should be inspected prior to use. Inspect the rail where the slide bearings make contact with the arm
(shown right) to remove any loose debris or dirt.
Y Axis Drive Belt Tension
The Y Axis drive belt must be secure, but not over-tightened. There should be minimal play in the transducer slide
block.
X Axis Maintenance
The X Axis should be inspected prior to use.
