LPX-1000 Scanner System
User Manual
Section 2
Copyright © 2008-2012 ATCO. All Rights Reserved.
850-004134
Page 8
Revision A.0
Remove (2)
Screws on Back
of YArm
Figure 13
Slide
Sprocket
Back
Slide
Block
Belt
Mounting
Clip
Figure 14
Maintenance and Storage
This section covers some basic maintenance and storage tips.
NOTE:
No internal components should need to be accessed; therefore disassembly of the scanner
should not be required and is not recommended.
Y Axis Maintenance
Changing the Y Axis Drive Belt
Occasionally the Y Axis drive belt needs replacement. Follow the steps show below to ensure proper installation.
Step 1
The first step in is to remove the existing belt. To do this, remove the two screws on the back side of the arm that
hold the sprocket mounting plate (Figure 12).
Step 2
The sprocket must be pulled back to allow the slide block to
move past the sprocket (Figure 14). Without moving the
sprocket, the belt mounting clip cannot move past it.
