LPX-1000 Scanner System
User Manual
Section 2
Copyright © 2008-2012 ATCO. All Rights Reserved.
850-004134
Page 10
Revision A.0
Place the Slide
Block back on the
Y Arm
Refasten the Clip to
the Slide Block with
the (2) Screws
Figure 18
Attaching the Slide Block to the Y Axis
Refasten the (2) Screws to the
Back of the Sprocket Bracket
but only finger tight
Figure 19
Fastening the
Sprocket Bracket
Tension the Belt and Secure the Screws
on the Sprocket Plate
DO NOT OVERTENSION THE BELT!
Figure 20
Tensioning the Belt
Step 6
Refasten the belt clip to the
slide block and place the slide
back on the Y Axis. (Figure
17) Be sure, once again, to
move the sprocket back so the
belt clip will clear it.
Step 7
Align the belt and place it on the two sprockets. Refasten the screws on the back
side of the sprocket bracket. Do not tighten them at this point (Figure 18 ).
Final Step
Tension the belt by pulling the sprocket outward. (Figure 19). Be careful not to overtension the belt. Secure the
screws on the back side of the sprocket
bracket.
