ATC VARENA 1000, Instructions For Use & Installation

Page: 7 / 20

VARENA
A73023342 7
VARENA
DIGITAL ELECTRIC RADIATORS
1. INTRODUCTION
Dear customer,
Thank you for choosing ATC VARENA electric radiators, with their modern design, state-of-the-
art technology, great reliability and great quality construction.
ATC VARENA electric radiators and all their materials and components have passed strict
controls to ensure their quality.
Before installing and operating your heater, please read these instructions carefully as they will
ensure the correct working order of the appliance features and ease of use. Keep them in a safe
place for future reference.
2. LOCATION
The radiator should be fitted in the part of the room where the client wants it, depending on the
space available, although preferably on or near outside walls, leaving enough space around the
heater for correct hot air circulation and at least 100 mm, from curtains and furniture, etc. The
distance should be at least 100 mm from the floor.
In bathrooms, the electric heater should be located outside of the protected area (Zone 1 & 2), as
indicated by Figure 1. Keep the fitting away from bath and showers.
Figure 1: Areas of the bathroom
3. ELECTRICAL CONNECTION
The Varena radiator must be connected to the mains supply (230 V ~ 50 Hz).
The maximum permissible impedance of the mains at the connection point will be:
Z
max
= 0.18 Ω.
It is required to install a switched spur for each heater. In addition, the following warnings must
be considered:
•
The electric radiator should not be located underneath a light switch where you need
to stretch over the heater to reach or operate the switch.
•
The electric line should be protected with a high sensitivity differential device
(RCBO).
•
It is necessary to de-energise or disconnect the power from the fixed wiring before
installation.
0,6 m
0,6 m
ZONE 1
ZONE 2
ZONE 3