GAME DOES NOT START
1.
Game
appears completely non-functional; no audio, no illumination, no video display.
A:
Check that the Power Switch has been turned ON (top left rear
the game cabinet).
B:
Turn OFF the game power. Unplug the A.C. line cord. Unlock and remove the cabinet rear door.
The Power Supply Line Voltage Switch must be set to agree with the local A.C. line voltage.
C: Remove the Line Cord Cover Plate. Test the line cord, power plug and I.E.C. connector for
Verify
each
Fuiiy seat the
connector
into the mating receptacle of the cabinet. Replace the cover plate and all four screws.
D: Ensure that cabinet wiring harness connectors are fully seated in the corresponding A.C. Power
Chassis Assembly connectors (refer to Power Wiring Diagram, Section Three).
E: Examine the A.C. Line Fuse on the A.C. Power Chassis. If the fuse is faulty, replace it with an
identical fuse from the spare parts bag. Replace the spare fuse when repairs are complete.
F: Fully seat the A.C. plug in the outlet.
Verify that A.C. line voltage is present. Turn the game
power ON. Check the D.C. wiring harness and connectors if the fuse opens the circuit again.
2:
Video
game appears non-functional, but currency acceptor price indicator is illuminated.
A:
Unlock and open the coin door. Inspect the CPU Board Assembly under low light level conditions.
A glow will be seen from the Light Emitting Diodes if there is voltage in the processor circuits.
This does not mean that voltages or signals are as they should be, but it does indicate that the
CPU Board is receiving some D.C. power from the Power Supply.
Turn OFF the game power, Unlock, open and remove the rear door. Inspect the CPU Board
Assembly. Ensure that the
Wire Harness connector is attached and fully seated onto the
mating board connector. Check the other wiring harness connectors in the same way.
CAUTION: DO NOT REMOVE OR INSTALL ANY CONNECTOR WHEN POWER IS TURNED ON.
DOING SO WILL DAMAGE THE GAME CPU BOARD ASSEMBLY AND VOID THE WARRANTY.
C: Verify that the game CPU DIP Switches are set as intended. Refer to the DIP Switch
Configuration Chart (Section One) for variables and default settings.
D: Turn ON the game power. Using the 20 Volt D.C. setting on a digital voltmeter, measure D.C.
voltages present at the Power connector pins. Adjust the
source if it is necessary. Refer to
the Cabinet Wiring Diagram (Section Three) for specific wiring information and voltage limits.
E:
Using the 2 Volt A.C. setting on a digital voltmeter, measure the same D.C. voltages as above.
Any reading here indicates that the supply voltages are unstable and may contain ripple or noise.
F: Verify that the
and completes the power-up self-test sequence without any errors.
Note errors and/or failures found during these tests.
G: Enter the game Menu System by pressing and holding the BEGIN TEST switch inside the coin
door. Select DIAGNOSTIC TESTS from the Main menu. Once in the DIAGNOSTIC TEST menu,
choose MONITOR PATTERNS (refer to Section One for additional details). Use this set of tests
to check the operation of each screen used in the game.
Summary of Contents for RAMPAGE WORLD TOUR
Page 41: ...CABINET WIRING DIAGRAM 3 4 ...
