Battery Installation
Before using the telephone, install a 9V alkaline battery (not included). In case
of a power failure,
the telephone will operate
normally if a fresh 9V
alkaline
battery is installed, but Caller ID, headset and speakerphone may not
work
properly. If AC power fails and there is no battery power, your volume
control will remain at the last setting until
the
AC power is restored. The
display
, ringer and
indicator lights
will not work until AC power is restored.
You will be
able to make and receive calls using only the handset only on Line 1.
This telephone
has a Memory Loss Protection feature and will store your Caller
ID
information, memory and programmed settings until power is restored.
When battery power is low,
is shown
on the
display.
Replace
the battery
promptly.
CAUTION:
Always disconnect all cords before installing a
new battery.
1.
Remove the label covering the display screen.
2.
Turn the telephone upside down.
3.
You may want to remove the desk wedge for easier access to the
battery cover. Push down on the tabs, and lift the wedge up and
away from the
telephone.
4.
Press the tab and pull to remove the battery cover. Insert one
new 9V alkaline battery (not included) following the polarity
markings in the battery compartment.
5.
Replace the battery compartment cover.
6.
If
the telephone is to be mounted on a wall,
turn to
Wall Installation
beginning on page 9.
— OR —
If you are using
the telephone
on a table or desk, turn to
Table/Desk
Installation
on page 6.
9V ALKALINE
BATTERY
9V ALKALINE
BATTERY
5
INST
ALLA
TION
INST
ALLA
TION
Audible Signals
WHEN YOU HEAR:
IT MEANS:
A long,
low-frequency
buzz,
An error has occurred. Try the
repeating (error tone)
operation again.
Three ascending tones
The operation
is
successful.
(confirmation tone)
Three beeps
You have reached the minimum
or maximum volume setting.
4
BEFORE
Y
OU BEGIN
BEFORE
Y
OU BEGIN
INSTALLATION
Polarity
markings
0992_CIB_1ATT_FINAL_022105 2/22/04 4:46 PM Page 4
a
B tt
