Table/Desk Installation
continued from page 7
4.
Connect the power cord.
CAUTION:
Use only the power
adapter
supplied
with this phone. If you need a replacement cord, call
1 (800) 222-3111
.
Fit the power cord behind the strain relief tab. Then plug the smaller
end of the power cord into the jack labeled
POWER
on the back
of the
telephone.
Plug the power adapter into a standard electrical
outlet not controlled by a wall switch.
5.
Check for
a
dial tone.
Press
L
, then lift the handset or press
S
and listen for a
dial tone. Then press
l
and listen for a dial tone. If you do not
hear a dial tone, see IN CASE OF DIFFICULTY beginning on page 55.
6.
Confirm Lines 1 and 2.
Press
L
and call one of
the telephone
numbers. If
you
hear
a busy
signal, you
have dialed
Line 1. If you hear a ringing signal in
the receiver,
then you
have dialed
Line 2.
9
8
INST
ALLA
TION
INST
ALLA
TION
INST
ALLA
TION
INST
ALLA
TION
Wall Installation
1.
Remove the desk wedge.
If the desk wedge is attached, remove it following the directions in
Battery Installation
beginning on page 5. Store
the wedge
in a safe
place in case this
telephone is used
on a table or desk in the future.
2.
Reverse the handset tab.
Hold down the switchhook, and slide the tab up and out of its slot.
Turn the tab so that the end with the
hook points
up, then insert the
tab back into its slot.
3.
Connect the power cord to the
telephone.
Fit the power cord behind the strain relief tab. Then plug the smaller
end of the power cord into the jack labeled
POWER
on the back
of the
telephone.
4.
Connect the handset to the telephone.
Plug the
handset cord
into the handset jack on the left side of
the
telephone.
Plug the other end of the
handset cord
into the handset,
then hang up.
continued on page 10
POWER
jack
Strain
relief tab
Figure 1
Figure 2
Figure 3
Power
cord
POWER
jack
Strain
relief tab
Power
adapter
0992_CIB_1ATT_FINAL_022105 2/22/04 4:46 PM Page 8
