CHAPTER 4: PC APPLICATIONS
DEFINITY Communications System
7400B Plus Data Module
Page 4-54
User´s Guide
bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Disconnecting a Call
1
Press
"F1" to return to the Main menu.
2
Select
"0" (End Communication/Program) at the "Enter
Selection" prompt.
3
Select
"H" to hang up (Smartcom II will hang up and reset the
7400B Plus).
4
To place another call, repeat the steps in the "Placing a Call"
section or select
"O" and press "E" to exit Smartcom II and
return to DOS.
ffffffffffffffffffffffffffffffffffffffffffff
PC to PC Calls
1
Call Originator
a
From the Main Menu, select
6 for Change Configurations.
From the Configurations screen, under Direct Connect
Port, select COM1.
b
At the parameter set to be used for the call, select
DIRECT <speed>
as the
Connection Type.
c
Select the Macro screen and edit the Automatic Log-on
Macro as shown below:
MACRO DEFINITION
Press F2 For Help
Name Of Macro: Z - Automatic Log-On
Set: Q - ATTMAIL
Time-out Prompt
Data
Send
CR
-------- ------
-----------------------------------
-------
0 0
(off)
atz^^
YES
1
0 (off)
at &c1 &d2 e1 v1
YES
1 0
(off)
atdt9,1-800-624-5123
YES
R(ecord, I(gnore, E(race: R
cc
c
c
c
c
c
c
c
c
c
bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
cc
c
c
c
c
c
c
c
c
c
bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Figure 46
Smartcom II - Initialization macro
d
From the Main Menu, select
O to Originate a Call.
2
Call Receiver
a
Follow the same steps as outlined above for the Call
Originator, but on the last line of the Automatic Log-on
Macro, replace the
atdt<phone#> entry with ats0=1.
