If the problem persists despite observing the instructions above,
call an authorized service technician. Elimination of any errors or
warranty claims that resulted from improper connection or use of
the appliance is not covered by our warranty. In such cases, the
costs of repair are borne by the user.
Sensors do not
respond, the display
has frozen
•
Disconnect the cooker from the power network for a few minutes
(remove the fuse or trip the main switch); then, reconnect it to
the power network and turn on the oven.
The main fuse is tripped
repetitively
•
Call a service technician!
Oven interior lighting
does not work
•
The process of replacing the bulb is described on page 75.
The oven does not heat
up...
• Was the temperature and operating mode selected appropriately?
• Is the oven door closed?
The pastry is not
cooked thoroughly...
• Have you removed the grease
fi
lter?
• Did you observe the instructions and tips from the section “Baking
pastry”?
• Did you follow the instructions in the baking table closely?
The program timer
shows extraordinary
fi
gures or is turned on
and off uncontrolled
• In case of faulty operation of the program timer, disconnect the cooker
from the power mains for a few minutes (remove the fuse or trip the
main switch); then, reconnect it to the mains and set the time of day.
Program timer display is
blinking
• There was a power supply failure, or your cooker was just connected
to the power mains. All set times have been deleted.
• Set the time of day to enable operation of the appliance.
• After the end of program timer controlled operation (automatic
operation), the oven goes off, the time of day is displayed, and an
audible signal is emitted for a certain period of time. Take the dish
out of the oven, return the operation mode selection knob and the
temperature knob/dial back to the starting position.
Operation control lamp
is not lit...
• Did you activate all necessary controls?
• Did the main fuse in your home network trip?
• Are the temperature knob /dial and the operating mode selection knob
set properly?
76
