Asystems DMP8800, User Manual

Page: 18 / 44

16
DMP8800
English
RM-6E PROGRAMMABLE REMOTE
With a single RM-6E you will be able to control up to 6
independent functions including gain control, channel
muting and matrix mixing� Up to eight RM-6Es can be
utilized at any one time�
SETUP
The rear of the RM-6E features 3 DIP switches that can
be utilized for identification of the unit� These correspond
with the 8 ports available within the DMA and DMP
software� The pin identifications and their corresponding
ports are as follows:
To assign a function to any of the RM-6E’s buttons, you
will need to enter the software of your DMA or DMP series
device� When in the software, navigate to the “Global
Settings” tab� Within this menu there is an “RM Control”
submenu that offers control of the RM-6E programmable
remote controls�
The “Port” option at the top of the page will correspond with
the port options found above� When the corresponding
port is selected, the 6 rows in the lower-half of the
page can be used to determine the operation of each
individual button on the RM-6E� Available functions are:
“Gain Control”, “Channel In Mute”, “Channel Out Mute”
and “Matrix Mixer”� The first three functions also have
a “Source” option that simply lets you select from an
available channel that you can then control� The “Matrix
Mixer” function has further options, allowing you to select
from the applicable matrix mix and input source�
Below the “Port” option in the control software, there
is also a “Lock” option� When a port is “locked”, the
corresponding functions of the RM-6E assigned to this
port will be deactivated and cannot be utilized using that
remote unit�
OPERATION
When a function is selected, pushing the RM-6E’s
corresponding onboard buttons will activate said
function� In the case of “Gain Control”, the up/down arrow
buttons are used to adjust the gain as needed� When a
“Mute” function is selected, simply pushing the button
will mute the selected channel/source� Finally, when the
Matrix function is selected, pushing the corresponding
button will route the signal selected to the mix selected�
Pushing it again will un-route the signal�
With up to 8 individual RM-6E units you’re able to set a
maximum of 48 individual gain controls, channel mutes
and/or matrix routing presets for use at any time�
WIRING
The RM-6E has an “IN” port that
can be connected to the RJ-45
“Peripheral” connector on the
DMA and DMP series of digital
matrix amplifiers and processors�
This is done using a typical
CAT5/6 cable�
A second RM-6E can then be
daisy-chained off the first by
connecting the “LINK” RJ-45
connector on the first to the “IN” connector on the second�
This can then be repeated for a third, a fourth, and so on�
You can use a maximum of 8 RM-6E’s together with your
DMP or DMA unit�
PORT
DIP
1 2 3 4 5 6 7 8