ASV PT-70, Service Manual

Page: 50 / 146

Side Panels/Gauges (MP-1)
Removal
1. Remove the screws securing the forward side
panel to the operator enclosure. (fig. 6-15)
2. Pull the side panel away from the cab as shown,
disconnect the gauges/switches from the wire har-
ness, then remove it from the machine. (fig. 6-16)
3. Remove the arm rests by first loosening the retain-
ing bolts from the outside of the cab, then slide the
rests up and out from the inside. (fig. 6-17)
4. Remove the screws securing the rear side panel
section to the cab enclosure. (fig. 6-18)
5. Disconnect any switches from the harness (unbolt
the heater control if removing left side) then
remove the panel from the machine (fig. 6-19)
6. If gauges need to be removed, remove the nuts
securing the bracket to the back of the gauge,
then remove the bracket and gauge from the
opposite sides of the panel. (fig. 6-20)
Side Panels/Gauges (MP-1)
Installation
1. To install the side panels or gauges, reverse the
removal procedure.
6-4
Rubber Track Loader
6. Operator Enclosure
6-15
Required Tools
Phillips Type Screwdriver
Combination/Socket Wrenches
6-16
6-17
6-18
6-19
6-20