ASV PT-70, Service Manual

Page: 120 / 146

Assembly
1. Install new seals and components in place of the
originals as necessary paying close attention to
location and orientation to ensure proper function.
2. Thoroughly clean all components to prevent sys-
tem contamination.
3. Reassemble components by reversing the disas-
sembly process.
Drive Motor
(brake portion)
Disassembly
1. With machine off and cool and with hydraulic actu-
ators relaxed, remove the drive motor from the
undercarriage by following the procedure in sec-
tion 13.
2. Remove all but four of the allen bolts (on opposite
sides of the cover) holding the rear cover onto the
drive motor, then back the remaining four out
evenly to release the light spring pressure against
the cover. (fig. 16-25)
3. Remove the rear cover to expose the brake
assembly. (fig. 16-26)
16-6
Rubber Track Loader
16. Hydraulic Component Service
Required Tools
Allen Wrench/Socket
Rubber Mallot (seal removal if needed)
Screwdriver (blade type) (seal removal if needed)
16-26
16-25