2-6
Chapter 2: RAID configuration
5. The RAID Properties screen shows the disks you can add to make up the
IM/IME volume. Use the arrow key to select a disk, then move the cursor to
the
Array Disk?
column. To include this disk in the array, press <+> or <->.
You may also specify the Hot Spare disk here. Select the disk, then move the
cursor to the
Hot Spare
column, then press <+> or <->.
By default, the
Array Disk?
field shows [No] before array creation. This field is
grayed out under the following conditions:
• The disk does not meet the minimum requirements for use in a RAID array.
• The disk is not large enough to mirror existing data on the primary drive.
• The disk has been selected as the Hot Spare for the RAID array.
• The disk is already part of another array.
Esc = Abort/Exit ArrowKeys=Select Item -/+ =Change [Item]
Home/End =Select Item Enter=Execute <Item>
F4=Diagnostic
LSI Logic MPT SCSI Setup Utility Version MPTBIOS-IME-5.10.03
RAID Properties Array: -- SCSI ID: -- Size(MB): ------
SCSI Device Identifier Array Hot Status Predict Size
ID Disk? Spare Failure (MB)
0 - [No] [---] -------- --- -----
1 - [No] [---] -------- --- -----
2 - [No] [---] -------- --- -----
3 - [No] [---] -------- --- -----
4 - [No] [---] -------- --- -----
5 - [No] [---] -------- --- -----
6 - [No] [---] -------- --- -----
7 1020/1030 [No] [---] -------- --- -----
8 FUJITSU MAT3073NC 0107
[Yes]
[---] Primary --- 70136
9 FUJITSU MAT3073NC 0107
[No] [---]
-------- --- 70136
10 FUJITSU MAT3073NC 0107
[No] [---]
-------- --- 70136
11 - [No] [---] -------- --- -----
12 - [No] [---] -------- --- -----
13 SDR GEM318 0 [No] [---] -------- --- -----
14 - [No] [---] -------- --- -----
15 - [No] [---] -------- --- -----
For creating IM volume, the system requires two hard disk drives and at least
three hard disk drives for IME volume.
Summary of Contents for PXL-S30R
Page 1: ...PXL S30R LSI 1030 SCSI RAID card ...
Page 12: ...1 Chapter 1 Product introduction ...
Page 40: ...3 Chapter 3 Driver update ...