P37
incompatible with the system and could damage the scanner.
•
Follow the manufacturer's instructions, recommendations, and guidelines for
cleaners and disinfectants, as well as your regional regulations.
• Check expiry dates, concentration, and efficacy of the chemicals used.
• Wear the appropriate personal protective equipment (PPE), such as eyewear and
gloves, as recommended by the chemical manufacture.
•
Repeated use and cleaning over the course of the scanner’s life may deteriorate
its cleanliness.
•
Using incompatible solutions to clean the scanner may damage its surface.
•
The scanner and its parts (including accessories) may not withstand the cleaning
or disinfecting processes (including repetitive process) specified in this manual
and may damage or deteriorate its safety provisions
.
•
Cleaning or disinfecting the scanner while the battery is charging may cause the
battery to short-circuit and overheat, causing an electric shock or burn.
•
Cleaning or disinfecting the scanner using other than IPA (isopropyl alcohol) may
damage it.
During an emergency where the scanner is used to examine multiple patients in a short
period of time, the lack of proper cleaning and disinfecting between patients may
spread infections to other patients and users.
Recommendations for cleaning the ultrasound probe as following step:
•
Turn off your devices before cleaning it.
•
To be ensured that all the coupling gel and other visible substances from the
probe is removed by wiping with a clean paper towel. If necessary, to remove
material dried to the surface, the cloth can be moistened with lukewarm water.
•
It shall inspect the probe’s lens and casing after each use. To check out any
damage that would allow liquid to enter the probe. If the user found a probe
damage, the probe shall not be placed into any liquid (e.g., for disinfection) and
shall not be used until it has been inspected and repaired/replaced by ASUSor a
local distributor for service.
Recommendations for disinfecting the ultrasound probe (After cleaning):
•
Spray 70% Isopropyl Alcohol onto the surface of probe head.
•
Repeat step one for two or three times.
•
Wipe out the disinfectant with a clean paper towel.
Maintenance
If this device is not functional, you may contact local distributor or contact ASUS by
email: [email protected]