Asus A7S333, User Manual

Page: 77 / 126

ASUS A7S333 motherboard user guide 61
4.4.2 I/O Device Configuration
Onboard FDC Swap A & B [No Swap]
This field reverses the hardware drive letter assignments of floppy disk drivers.
Configuration options: [No Swap] [Swap AB]
Floppy Disk Access Control [R/W]
When set to [Read Only], this parameter protects files from being copied to
floppy disks by allowing reads from, but not writes to, the floppy disk drive.
The default setting [R/W] allows both reads and writes. Configuration
options: [R/W] [Read Only]
Onboard Serial Port 1 [3F8H/IRQ4]
Onboard Serial Port 2 [2F8H/IRQ3]
These fields set the addresses for the onboard serial connectors. Serial Port
1 and Serial Port 2 must have different addresses. Configuration options:
[3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] [Disabled]
UART2 Use Standard Infrared [Disabled]
This field assigns the UART2 to the infrared. Configuration options: [Disabled]
[Enabled]
Onboard Parallel Port [378H/IRQ7]
This field sets the address of the onboard parallel port connector. If you
disable this field, the Parallel Port Mode and ECP DMA Select configurations
are not available. Configuration options: [Disabled] [378H/IRQ7] [278H/IRQ5]