14
© 2017 Directed. All rights reserved.
Remote Start/Stop
Press
and
release
Activate the remote starter. The engine and parking lights turns on and the 2-way
remote control confirms the activation by text, icon and tone. or the engine and
parking lights turn off and then the 2-way remote control will update to confirm
shutdown.
Press
and
hold
the
icon for at least 4 seconds to remotely stop the engine.
The parking lights turns off and the 2-way remote control confirms by using text,
icon and tones.
If the remote start fails to turn on, the remote control will display an alert by text,
icon, or tone, and the vehicle parking lights will flash to indicate the cause. Refer
to the following table for the likely cause.
Alert Conditions:
Parking Light
Flashes
Possible Cause
Solution
5
Brake ON
Release Foot Brake.
6
Hood Open
Close Hood.
7
After performing Remote Start
command MTS not enabled.
Enabled MTS Mode.
9
Start Valet on
Turn Start Valet off
Valet Modes
Remote Valet Modes
The Valet commands in the remote command table turn on/off the Alarm Valet,
Start Valet, or Combo Valet Modes (both Alarm & Start Valet).
•
Alarm Valet ( +
)
The Alarm Valet mode will disable included alarm features when armed/
locked. It also disables any passive arm/lock settings if programmed on.
The 2-way remote control confirms by using text, icon, or tones.
•
Start Valet (
+
)
The Start Valet mode will disable remote start features until turned off. The
2-way remote control confirms by using text, icon, or tones.
