ASTRO AstroJet 1000, Installation And Operating Manual

Page: 9 / 57

5
Section 2 –
Installing the AstroJet 1000
To install the AstroJet 1000 printer the following must be done:
•
Choose a location for the AstroJet 1000 Printer
•
Plug in the printer and connect it to the computer
•
Install the Inkjet Cartridges
•
Set up the feed on the printer
•
Install the AstroJet 1000 software on the computer
•
Create a job to be printed (refer to Section 4 – Software Tutorial )
Choose a Location
The AstroJet 1000 should be placed on a sturdy worktable or cabinet at least 12 inches from any
walls. Protect the AstroJet 1000 from excessive heat, dust, and moisture – avoid placing it in
direct sunlight.
Connecting the AstroJet 1000
Plugging in the Printer
Make sure that the main power switch of the AstroJet 1000 Printer is in the OFF position.
1. Connect one end of the power cord to the
rear of the AstroJet 1000 in the
corresponding receptacle.
2. Plug the other end into a 115-220 Volt AC,
50/60 Hz. Grounded outlet.
CAUTION
Do not use an adapter plug or extension
cord to connect the printer to the wall
receptacle.
Do not use outlets controlled by wall
switches.
Do not use an outlet that shares the same
circuit with large electrical machines or
appliances
.
Connecting to the Computer
Plug the parallel printer cable from your computer
into the rear of the printer and latch the two locking
clips.
The cable used to connect the AstroJet
1000 to the computer must not exceed 6 feet
long.