![Astro Machine AstroJet 5000 Operator'S Manual Download Page 29](http://html1.mh-extra.com/html/astro-machine/astrojet-5000/astrojet-5000_operators-manual_2991077029.webp)
SECTION 4
MAINTENANCE
25
Misfeeds
Misfeeds cause the printer to stop and the Red light in the Paper Feed switch will blink. Press this switch
to restart the printer and feed the sheet. If the sheets continue to fail to feed, readjust the sheet separators to
the media or replace them.
Replacing the Sheet Separators
The sheet separators insure separation of the pieces as they are being fed. The do wear and must be
replaced from time to time. If you experience double sheet feeding and can not adjust the separators to
prevent it, they should be replaced. Replacement of the sheet separators is not difficult. Just follow the
steps below:
1.
Turn off the AstroJet 5000 and unplug it from the power source.
2.
Release the separator-by loosening knob [A]
and move the paper side guides to their
maximum open position.
3.
Lower the separators so that they touch the
feed roller.
4.
Remove the screw [B] and the separator
support [C.] Then remove the separator [D]
by prying it out of the holder.
5.
Install a new separator in place and replace the
separator support and screw.
Cleaning
The AstroJet 5000
WARNING
THE PRINTER IS A PRECISION MACHINE THAT SHOULD BE CLEANED
REGULARLY TO INSURE MANY YEARS OF SERVICE. BEFORE PERFORMING
ANY MAINTENANCE DISCONNECT THE MACHINE FROM ITS POWER SOURCE!
The Printer must be cleaned regularly of accumulated paper dust and ink. Depending on the types of media
that are run, paper dust may accumulate within the printer and on the transport. Unplug the printer from the
power receptacle and remove the covers.
The internal areas are best cleaned with a vacuum that has a soft brush attachment to help loosen the dust
particles. Take care not to damage the PC Boards or electrical wiring.
The exterior of the machine may be cleaned with any standard household cleaner which is non-abrasive and
does not contain plastic harming solvents.
CAUTION
NEVER SPRAY OR POUR CLEANERS DIRECTLY ON OR INTO THE PRINTER.
EXCESS LIQUID COULD HARM ELECTRONIC PARTS. ALWAYS DAMPEN A RAG
WITH THE CLEANER AND APPLY IT TO THE PARTS TO BE CLEANED.
Summary of Contents for AstroJet 5000
Page 37: ......