35
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Operation
900301-01 04/2017
Innovative Hearth Products
Marin™ See-Through B-Vent Gas Fireplaces
NOTE: Front Face Assembly with
barrier installed must be rein-
stalled prior to operation.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
Only doors certifi ed with the appliance
shall be used.
Seules des portes certifi ées pour cet
appareil doivent être utilisées.
WARNING: DO NOT abuse glass door by
striking or slamming shut.
These are B-vent appliances. They are designed
to operate only when the glass enclosure panels
are installed. Generally the glass enclosure panels
should not be removed except to gain access to
the components within the fi rebox.
Removing Glass Enclosure Panels
(see
Figure 38
)
To access the glass door securing latches, fi rst
remove the hood by pulling fi rmly straight away
from the unit. Remove the front face assembly by
lifting up top and bottom evenly approximately
1/2" and pulling straight out from the unit once
the brackets are disengaged.
Remove the bottom compartment door by
sliding the hinge pin, located at the door’s left
side, to the right until it disengages from the
left corner post hole. Pull the door diagonally
to the left, away from the fi replace.
Locate the latch at the top of the control com-
partment and disengage them from the door
frame bottom vee-fl ange, pulling down on its
handle to open it.
Installing Glass Enclosure Panel
(see
Figure 38)
Retrieve the glass door. Visually inspect the
gasket on the backside of the frame. Gasket
surface must be clean, free of irregularities
and seated fi rmly.
Position the door in front of the fi rebox opening
with the bottom of the door held away from the
fi replace
(Figure 38)
. Hook the top fl ange of the
door frame over the top of the fi rebox frame.
Let the bottom of the door frame swing gently
in towards the fi replace ensuring that the gasket
seats evenly as the door frame draws shut.
Fasten the latch located underneath the fi rebox
fl oor to the door's vee-fl ange. Close both the
latch securely.
Figure 38
Glass
Door Latch
Front Glass
Enclosure Panel
Firebox Floor
Bottom Vee-flange
Glass Door Frame
Top Flange
Glass Door Frame
NOTE: When installing the glass door, ensure the
spacing on both sides is even and equal.
Front Glass Enclosure Panel, Removal
and Installation
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
WARNING
•
Do not attempt to substitute the
materials used on these doors,
or replace cracked or broken
glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as
a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass sepa-
rately.
•
Do not attempt to touch the
front enclosure glass with your
hands while the fi replace is in
use.
•
DO NOT abuse glass door by
striking or slamming shut.
WARNING
The door should easily close
without needing to be pressed
down. If it has to be pressed
down to close, the gasket in the
top of the door should be dressed
so it lays on the glass.
