Inst 276 - Viron Connect Pool & Spa Controller V0610
6
e. USE SEPARATE POOL AND SPA
MODES
i. If you have both a pool and spa connected on the one system, select YES. This will allow
for the operation of motorized valves
ii. Select
NEXT
f.
CHANNEL 1
i. Select use for channel 1 on the Viron Connect. Options are Unused, Lighting or Pool
Equipment.
ii. If you select Pool Equipment, you will be prompted to choose the purpose
of the
equipment connected to this channel (i.e. Filter Pump, Waterfall, Blower, etc)
iii. If Filter Pump is assigned to this channel, you will be asked if you have a Viron
3 speed
pump on the system. If YES is selected, you will then be prompted to select the
default
operating speed. For most applications either Low or Medium should be selected.
iv. If you select Lighting, you will be prompted to select one of the lighting zones set up
earlier in the installation.
v. Select NEXT
g. CHANNEL 2 thru 8
i.
Repeat steps as per
CHANNEL 1
h. IS CLEANING INTERLOCK
REQUIRED?
i. If you have infloor cleaning installed into your swimming pool or have a pressure cleaner,
this can be linked to the main filtration pump to ensure they operate together. For this
feature to work, you must have nominated one of the channels earlier as CLEANING.
i.
IS HEAT DEMAND REQUIRED?
i. This feature will activate the main filtration or heating pump for a 3 minute
period each
hour. During this time, the heater will sample the pool water to see if it is above or below
the set point. If the water has fallen below the set point, the heater will activate and keep
running until the water reaches the desired setting. Both the heater and pump will then
switch off.
j.
SUMMARY
i.
A summary of settings will be displayed. You can accept by pressing
EXIT, or make
alterations by pressing CHANGE
k. Select the MENU icon to return to the main menu.
