15
Viron e-Quilibirum Series Chlorinator
Installation Manual
14
Viron e-Quilibirum Series Chlorinator
Installation Manual
6.4
Basic App Functions
Figure 16.
ChlorinatorGo App - Home Page
Functions available from the App are:
• Chlorinator - set On, Off, Auto
• Pool or Spa Mode
• Set pump speed (if a compatible AstralPool pump is installed)
• pH and ORP readings (if pH and ORP probes are fitted)
• Lights - on, off (if a compatible Connect LITE or Connect LITE+
is installed)
• Timers - add, change (if Timers Enabled is selected)
• Chlorine Set Point
• Maintenance Functions
Figure 17.
ChlorinatorGo App - Timers
Section 7.
Pool Chemistry and Balance
7.1
pH Regulation Principle
The amount of chlorine needing to be produced is
dictated by the pH level in the pool. As the pH level
rises, the amount of chlorine must be increased to
compensate, see below.
+
-
10 min
10 min
10 min
10 min
Dosing Cycles
Time
pH
pH evolution
7,30
7,35
7,40
7,45
7,50
7,55
7,60
7,65
7,70
7,75
7,80
7,85
7,90
7,95
8,00
8,05
8,10
8,15
8,20
100%
75%
50%
20%
Factory Set Point = 7,4 pH
Figure 18.
pH Evolution Graph
7.2
Chlorine Output and Filtration Time
Your Chlorinator must be run every day to ensure that
your pool is correctly sanitised. As the sun dissipates
chlorine, running times are higher in the summer
compared to the winter. AstralPool recommend that
you initially run your chlorinator at maximum output
on level 8.
7.2.1
Summer
Set the Chlorinator to operate for 8 to 10 hours
per day. Ideally, run it for 4-5 hours in the morning
(between 8-12pm) and 4-5 hours in the evening
(between 6.00-11pm).
In extremely hot weather it may be necessary to
extend the running time if you find that the free
chlorine level is too low.
7.2.2
Winter
You should set your Chlorinator to operate for 6 to 8
hours per day. Again, running it in the morning and
evening is preferable. A lower chlorine output level
may be selected.
