Astoria Gloria AEP, Instruction Manual For User

Page: 177 / 296

29
English
SAE - DISPLAY
ENGLISH
If the machine will not work call technical assistance.
i
The above procedure allows resetting to zero of the counts of each push button panel while leaving the
total counts of the machine unchanged (life cycle of the machine).
i
1) Turn the programming switch on OFF;
2) Keep the PROG key pressed for 5 seconds;
3) Turn the programming switch on ON;
4) Press the key to start the zero setting;
5) Press the UP ARROW key for at least 3 seconds to confirm the zero setting.
data reset
reset counting ?
press + 3 sec.
total coffees
00000000
11.3 Resetting selection count to zero
1,1 bar 120°C
boiler filling
cause solution
1,1 bar 120°C
filling timeout
Boiler filled with water when using the machi-
ne for the first time or when refilling to reach
the water level.
doser alarm
Wait for the boiler to be completely filled.
reg. softener
Time for filling the boiler with water longer
than expected.
Make sure the water mains cock is opened.
Switch the machine off and back on again.
If the warning is still on after a few at-
tempts, call Technical Assistance.
Fault of the volumetric electronic control
Stop delivery by pressing the dose key. Call
the Technical Assistance.
12.
S
ignals
Water softener regeneration request
Carry out the water softener regeneration.
To put off the warning turn the program-
ming switch on ON and press simultane-
ously the 4 display keys
for 5 seconds
1) Turn the programming switch to ON ;
2) Simultaneously press the 4 keys PROG
of the left push button panel until the display shows the signal.
3) to bypass regeneration control, set a value of 00000 litres.
11.2 Reset of water litres count for softener regeneration
reg. softener
00000
reg. softener
00000