NOTE:
As with the acrylic assembly, the glass panel assembly is heavy to lift.
Please use caution when lifting this assembly and use two people to lift it into
place.
1. Lift and place the glass panel assembly onto the base and acrylic panel
assembly.
2. Once in place verify the alignment of all holes between the acrylic walls and
the glass assembly.
NOTE:
The acrylic walls should align with the aluminum frame of the glass panel
assembly. If you find they do not investigate the cause and try to determine the
issue. If no issues can be found then you can add or enlarge holes as needed in
the acrylic. We do not recommend adding holes into the aluminum frame;
however, if you choose to add additional holes to the aluminum frame choose a
drill size that is smaller than the minor diameter of the screws provided.
3. After verifying the hole alignment, remove the glass panel assembly.
4. Apply a liberal bead of sealant down each side of the acrylic walls in line with
where the glass panel assembly will be in contact with the mounting holes.
5. Apply an additional bead of sealant along the base where the glass panel
assembly will sit.
Step 7 Install the glass panel assembly on to the base
21
M4x16
SCREW PACK
(4)
