NOTE:
The acrylic wall assembly can be heavy so please use caution when lifting
it and placing it onto the base.
1. Lift and place the acrylic wall assembly onto the base to dry fit and check for
proper hole alignment.
NOTE:
The base should align to the acrylic wall assembly. If you find it does not,
then investigate the cause and try to determine the issue. If no issue can be found
for the misalignment, you can enlarge the holes or add additional holes.
If you choose to add a hole, make sure to pilot drill first so you so do not crack or
chip the acrylic. Use a pilot drill size that is smaller than the minor diameter of the
screw to be used. If you adding additional mounting holes then you will need to
get the necessary hardware as it is not provided.
2. After checking the hole alignment, remove the acrylic wall assembly from the
base.
3. Apply a liberal bead of sealant onto the base in line with the mounting screw
holes.
4. Place the acrylic wall back onto the base and align the mounting holes.
5. Use the
M5 X 25mm
screws from the
Screw Pack 2
insert and start all
screws in their respective holes, but do not fully tighten.
Leave the screws hand tight only until the unit is fully assembled. This will aid in
the alignment for the next step in assembly.
Step 6 Install the acrylic wall assembly on the base
20
M5x25mm
SCREW PACK
(2)
