5
An ASSA ABLOY Group brand
P/N AYRT-210-INST-FUL Rev E
Preparation
A. Remove the latch (Fig. A) and strike plate from the packaging.
If required, pull to extend to 2-3/4" backset position (Fig. A).
NOTE
: Different holes are used for (2) through bolts depending on backset (see Fig. A).
Figure A
2-3/8" through bolt posts
2-3/4" through bolt posts
Before installing the lock on the door:
NOTE
: The latch can be installed in only one of two ways - with the
bevel
(slope) of the
latch facing out or facing in
while standing exterior of the door.
NOTE
:
Both latch face and strike plate have adhesive-backed covers to prevent marring and
should be removed upon installation.
IMPORTANT: Latch bevel must match door bevel
and plunger of deadlocking latch must stop on
strike plate when door is closed.
Make sure door has been prepped according to specifications in template
included with lock.
If the door opens
in
, the bevel will face the exterior (regular); if
the door opens
out
, the bevel will face the interior (reverse).
Strike plate
Plunger
NOTE
: Latch ships with backset in 2-3/8" position (Fig. A).
Backset
is the measurement from door edge to center of 2-1/8" diameter hole
(see template supplied with lock).
INSTALL LOCK
