20
An ASSA ABLOY Group brand
P/N AYRT-210-INST-FUL Rev E
Cycle the lock in both the locked and the unlocked positions. If problems are found:
TROUBLESHOOTING
Hardware Troubleshooting
Symptom
Suggested Action
Door is binding
a. Check that door and frame are properly aligned and door is free swinging.
b. Check hinges: They should not be loose or have excessive wear on knuckles.
Latch will not deadlock
a. Check for sufficient clearance of the latch within the strike-side jamb. Correct this by
increasing the depth of the pocket for the latch.
b. Check for misalignment of latch and/or strike plate which may be preventing latch from
properly entering the strike plate. With the door open, extend and retract the latch; if it is
smooth, check the strike plate alignment.
Latch does not extend or retract smoothly
a. Latch and strike plate are misaligned, see above.
b. Check the backset of door relative to adjustments already made to latch.
c. Verify proper door preparation and re-bore holes that are too small or misaligned.
d. Verify keypad wire harness is routed under the latch (see Fig. A).
e. Verify latch is installed with correct side up (Fig. A).
MISCELLANEOUS
Hardware Troubleshooting ......................................................................................20
Programming Troubleshooting ...............................................................................21
Installing the Network Module ...............................................................................22
Replace/Install Cylinder .........................................................................................22
Sample PIN Code Management Sheet ...................................................................23
Interior of Door
Figure A
