October 11, 2011
Page 11 of 22
66 3081 018-4
5.
Depending on the connection status of the safe, it will display either ‘On .’ or ‘OFF .’.
The ‘On .’ status indicates that the safe is connected to the ZigBee network. If ‘On .’ is displayed,
the safe interface (PinKey, ElKey or IR) can be removed from the service socket.After that, the safe
should appear in the
ZigBee Network
window of SysMon (System Monitor) with the room number
that was set during the commissioning.
If the signal to the ZigBee network is weak ‘OFF .’on the safe display), it might be necessary to repeat
the procedure of connecting the safe to the ZigBee network; see section 3.1.2. The endnode must then
be set in discovery mode again according to steps 1-3 above.
The picture below shows a sample of the ZigBee network view, with safes connected to three
different routers.
