05/15/15
Copyright © 2015, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Harmony Series H1 Mortise Lock
A7877F • 800-810-WIRE (9473) • www.sargentlock.com 11
1. With outside lever horizontal, insert the mounting post through outside of door and lock body.
Make certain the lever spindle is properly engaged inside the lock body (Fig. 9A).
2. On the inside of the door, insert spindle into square hole of mortise lock (Fig. 9B).
3. Slide inside adapter and plate
assembly over spindle and
loosely secure with (2) 8-32 X 5/8”
Phillips oval head and lock washer
machine screws.
Be sure to rotate the set screw hole
so the hole (Studio Collection only)
faces the hinge side and seat the
inside spindle fully into the lock body.
4. Securely tighten the
lock body screws.
Fig. 9B
Fig. 9A
Mortise
Lock body
Screw
8-32 X 5/8”
Phillips Oval
Head and
Lock Washer
Machine
Screw
Mortise
Lock body
Screw
1. Connect P3 (2-pin connector) from lock body to J3 on interior
PCB assembly.
2. Connect P4 (6-pin connector) from lock body to J4 on interior
PCB assembly.
3. Connect P5 (7-pin connector) from Reader board to J5 on interior
PCB assembly.
4. Connect ElectroLynx harness (4 and 8-pin) from door harness
to ElectroLynx harness on interior PCB assembly.
NOTE: Connectors go on only one way.
Do not offset connector and be sure
they are completely seated.
Fig. 10A
Inside of Door
Outside of Door
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
J1
1-Violet Lock Neg
(Actuator, neg)
3-Pink
DPS (NC)
1- Black
PWR NEG
3-White
DATA 1
5-Orange
RX (NO/NC)
7-Brown
EGND
2-Gray Lock Pos
(Actuator, pos)
4-Tan
DPS (COM)
2-Red
PWR POS
4-Green
DATA 0
6-Blue
RX (COM)
8-Yellow
LED
From Reader
Board P5 to J5
From Lock
Body P3 to J3
From Lock
Body P4 to J4
To ElectroLynx Harness
J1
J2
8 Outside Lever and Inside Adapter Plate Assembly Installation
9 Connect ElectroLynx
