ASL INTERCOM T9 PRO, Owner'S Manual

Page: 7 / 28

T9 PRO - 5
ASL MACHINES USA 2018 ©
and a mild detergent. Squeeze out excess
water (do not wring out). Allow the filter to air
dry before replacing. Failure to the engine filter
clean may result in engine overheating.
Never attempt to adjust the fuel system
of a propane engine! if equipped with an
emission monitoring or controlling system,
never attempt to disconnect or circumvent
it. promptly report problems to supervisor.
Remember that being safe is a full-time,
every day job. follow all information
posted on the machine and the LPG tank.
Never allow anyone to operate this
machine who has not read or cannot
understand the given instructions.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this machine. always store equipment
away from heater rooms, boilers, gas-
fired water heaters or any other source of
open flame. propane is highly flammable.
always store LPG tanks (full or empty)
outside in a secure, well ventilated area.
NO SMOKING, NO SPARKS, NO FLAMES,
NEAR UNIT OR LPG TANK.
This machine emits CO (carbon monoxide),
which is a colorless, odorless, non-irritating
gas. symptoms of CO exposure include
headache, drowsiness, dizziness and nausea.
if you experience any of these symptoms
during machine operation, immediately shut
off the machine and go outside for fresh air.
Have a qualified service technician test the
machine for CO emissions before using it
again.
High exposure to CO may result in vomiting,
confusion, collapse, loss of consciousness
and muscle weakness. if such symptoms
occur, call for emergency medical attention.
do not operate this machine or other propane
powered equipment until cleared to do so by
a physician. excessive exposure to Co can
result in death.
Never change or alter the propane control
components.
this machine is factory equipped with
engine components and emission
controls that maintain harmful exhaust
emissions below certi ed acceptable levels.
nevertamper,adjust,orremoveanyfactory
installed engine components for purposes
other than maintenance, repair or
replacement.
never tilt the equipment on its side for pad,
belt or brush replacement. it is designed
to tilt back on its rear wheel and handle for
maintenance and repair. a second person
should aid in lifting and securing equipment
for repair.
never tilt & transport while engine is running.
Keep hands and feet clear of all moving parts.
WARNING!
WARNING!