ASL INTERCOM T9 PRO, Owner'S Manual

Page: 6 / 28

4 - T9 PRO
ASL MACHINES USA 2018 ©
Do not allow machine to come into contact with
loose tiles or other obstructions on the floor.
the abrasives will be turning at approximately
650 Rpm. If objects are hit, they could become
dangerous projectiles!
• Extend the handle and tilt machine back until
handle rests on oor.
• Install diamonds and remove transport wheel.
• Bring machine back to operating position.
• Fill water tank if wet grinding.
I. Preparing to start the engine
1. First - check fuel cylinder for over ll and
install cylinder onto machine.
2. Place machine on level surface and check for
correct oil level.
J. transporting the machine
1. The tank should be securely fastened.
2. The tank valve must be closed.
STARTING THE ENGINE
1. Open propane (LPG) tank valve (counter
clockwise).
2. Turn the key to start position and move
throttle towards fast position.
3. If engine does not start, release the key, then
try again.
4. Equipment is supplied with a centrifugal
clutch. When engine RPM is lower than 800
RPM clutch will disengage; drivers will stop.
5. Increase throttle to about 75% while walking
very slowly.
A. NEVER TILT BACK MACHINE WHILE
ENGINE IS RUNING
STOPPING THE ENGINE
Turn the propane tank valve clockwise to a
closed position and turn the key OFF.
NOTE: The exhaust system will be very hot and
takes several minutes to cool, so keep yourself
and all materials clear.
MAINTENANCE
A. Cleaning the equipment
1. Place machine in “tilt back” position.
2. Rinse the drive unit and drivers.
3. Rinse around splash skirt and body.
4. Return machine to operating position, then
start engine and run machine briefly to expel
any excess water.
B. Storing the machine and tank
1. The engine should be stopped properly and
the tank valve closed.
2. Remove the LPG tank from the machine and
store the tank in a well ventilated approved
area.
3. Store your machine in a safe area: away
from enclosed high heat, away from sparks or
ames, and away from traf c lanes of heavy
equipment.
D. Machine & Engine Maintenance
1. Refer to engine manufacturer’s Owners
Manual and comply completely with the
instructions. Change the oil and filter according
to the engine Owners Manual.
2. Keep a good service log on each machine
with the date, hour meter reading, type(s) of
service performed and the name of the person
who performed them.
3. Clean the entire unit after each use. When
cleaning the unit, check for possible loose nuts
and bolts.
4. The foam engine dust filter should be
removed and cleaned periodically by shaking
out the accumulated dust and rinsing with water