ASL INTERCOM T9 PRO, Owner'S Manual

Page: 4 / 28

2 - T9 PRO
ASL MACHINES USA 2018 ©
IMPORTANT SAFETY INSTRUCTIONS
Read and observe all DANGER, WARNING,
and CAUTION statements included in the
owner’s manual and af xed to the machine.
These statements indicate that there is
a possibility of death, bodily injury, and
damage to the machine or property if these
instructions are ignored.
Operate only in well ventilated areas.
Buildings must be provided with:
A. Acontinuous mechanical ventilation that
removes the products of combustion to the
outdoors of not less than 300 CFM for each
10,000 BTUH or fraction thereof; or
B. Natural ventilation of not less than 300CFM
for each 10,000 BTUH input or a fraction
thereof; based on a maximum of one-quarter
air exchange per hour for the net building
volume.
If you smell LPG gas, stop the unit and check for
leaks. also open windows, don’t touch electrical
switches, extinguish any open flames. Call your
gas supplier if no leaks are found.
Do not adjust the fuel system without the proper
analysis equipment.
DO NOT OPERATE THIS MACHINE IN AN
EXPLOSIVE ENVIRONMENT!
THIS PROPANE MACHINE IS INTENDED FOR
COMMERCIAL USE.
TRANSPORTING THE MACHINE
NEVER TRANSPORT WHILE ENGINE IS
RUNNING.
To transport the machine it is necessary to install
the transport wheel so the drive plates are not in
contact with the floor. In this “balanced” position
the equipment can be readily moved from site to
site.
A. Tilting the Machine
This is a heavy piece of equipment. Caution
should be used in tilting the machine. This can be
accomplished safely and easily as follows:
1. One man method:
a. Standing behind the machine, place one
foot on the brace at the base of the propane
tank.
b. Place one hand on the handle and the
other on the “T” frame handle support.
c. While pulling and leaning back, lift the
other foot off the floor and extend it directly
behind. This will shift the balance and
naturally tilt the equipment to transport or full
“tilt back” position without undue strain.
2. Two man method:
Two people side by side perform the above
procedure simultaneously. This is a safer,
more comfortable technique to use until more
experience is gained with the equipment.
Do not use excessive vertical pressure.
B. Position for Maintenance & Cleaning
To perform certain maintenance & cleaning tasks
or to change diamonds, the machine should be
placed in the full “tilt back” position. See page
8 for more information about maintenance and
cleaning.
PREPARATION
Flange bearing must be lubricated before
every use. See page 8 for more information
about the flange bearing.
A. Check that the suggested maintenance
schedule has been observed. See page 8-9 for
more information about suggested machine and
engine maintenance instructions.
All machines are equipped with a multi-function
maintenance meter. The functions include
the following: hour meter, service alert and
tachometer. (See Engine Maintenance Meter
instructions pg. 9).