ASL INTERCOM T9 PRO, Owner'S Manual

Page: 21 / 28

T9 PRO - 19
ASL MACHINES USA 2018 ©
[6]: Ensure throttle is set to the STOP position as shown in figure 4 above.
[7]: If wet cutting, and optional water tank is installed, turn the water on using the water valve as
shown in figure 5 Below.
[8]: If dry cutting, ensure vacuum is properly connected as shown in figure 6 below.
FIGURE 5 FIGURE 6
[9]: Turn on the propane tank and start the motor by turning and holding the key to the start position
until the motor starts as shown in figure 7 below.
FIGURE 7
[10]: Slowly increase the throttle speed until desired RPM setting is achieved.