Asko TL751 XXLT, Service Manual

Page: 20 / 61

19
2-3. Operation of Load and Sensor
1) Operation of Heater - Electric Type
➔
On/Off goes on according to temperatures set or measured by the sensor. Regardless of the control by
the microcomputer, however, the heater may go off if a temperature reaches Thermostat Off
Temperature as per outlet conditions.
➔
As regards temperature setting, refer to 2-4 (button operation and temp control).
➔
If you stop the unit temporarily, the machine stops operating until it resumes the function.
➔
If Sensor Course is selected and Temp Control is set to Low or Ultra Low, only the outer heater
operates. Two heaters function if other temperatures are selected.
➔
If Manual Course is selected and Temp Control is set to Low or Ultra Low, only the outer heater
operates. Two heaters function if other temperatures are selected.
➔
If Time Dry Course is selected and Temp Control is set to Ultra Low, only the outer heater operates.
Two heaters function if the temperature is set to Low.
➔
The heater goes off if Cooling or Wrinkle Care is selected.
➔
The heater goes off if Air-Dry of Manual Course is selected, for Temp Control is not available.
2) Operation of the Motor
➔
The motor continues its function once operation starts.
➔
The motor stops if you stop the unit temporarily.
➔
The motor continues to operate during Cooling.
➔
If Cooling or Wrinkle Care is selected, the motor turns on for 10 seconds and off for 5 minutes and 50
seconds.
3) Door Control
➔
The heater and motor operate only the door is closed.
➔
If the door is opened during the operation, the heater and motor turn off. If you press Start Button while
the door is opened, LED goes on for a second.
➔
The unit operates only after the door is closed.