25
You can optimise the two automatic programs for the best possible result.
The setting is adjusted on the control panel for the program concerned.
Adjustments must be made if it is found that the:
■
Washing does not dry su
ffi
ciently.
■
Washing is over-dried – long drying time.
INTRODUCTION
The drying cabinet’s two automatic program stop automatically when the laundry
is dry. To decide when the washing is dry, a measured value is compared against a
factory-set parameter.
■
Parameter
P 2072
for
NORMAL DRY
drying program and
■
Parameter
P 2071
for
EXTRA DRY
drying program.
It is primarily these two parameters that are adjusted to optimise the drying process.
■
The NORMAL DRY program is controlled by a
moisture sensor.
■
EXTRA DRY program is controlled by a
moisture sensor and a time factor.
■
If it is found that the washing does not dry su
ffi
ciently in the:
NORMAL DRY
drying program,
the parameter value for
P 2072
is
reduced.
EXTRA DRY
drying program, the parameter value for
P 2071
is
increased
.
■
If it is found that the washing is over-dried, long drying time in the:
NORMAL DRY
drying program,
the parameter value for
P 2072
is
increased.
EXTRA DRY
drying program,
the parameter value for
P 2071
is
reduced.
Drying processes must always be optimised in small steps; start by adjusting the
parameter concerned 1-2 units up or down, then check the result after the next
drying process and make a further adjustment if necessary.
OPTIMISING THE DRYING PROGRAM
859149au_en.indd 25
859149au_en.indd 25
17. 02. 2022 08:51:25
17. 02. 2022 08:51:25
