Page 2
Customer Care Center
1-800-898-1879
www.askona.com
TOOLS
1)
Phillips No. 2 screwdriver
2)
Flat blade screwdriver
3)
Torx screwdriver size T 20
4)
Adjustable wrenches (if you use copper fittings)
5)
Open-ended wrench (1/2˝ [12 mm] or 5/8˝ [16
mm])
6)
Tape measure
7)
Spirit level
8)
Electric drill with 1-1/2˝ drill bit
9)
Keyhole saw
MATERIALS
•
Minimum 3/8" OD copper tubing of sufficient length for
your installation.
•
Shut-off valve and fittings for water supply line.
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
If a dishwasher is being installed in this area for the first
time, most of the cabinet work, plumbing, and electrical
has to be done before you move the machine into place.
NOTE:
Cosmetic damage must be reported to the ASKO dealer
within five days from the date of purchase. As soon as
you unpack the dishwasher, thoroughly check it for
cosmetic damage.
If you are replacing an old dishwasher, you must check
the plumbing connection and wiring before you move
the new dishwasher into place.
INTRODUCTION
WHAT YOU NEED
The dishwasher is shipped with the high loop drain
hose, inlet hose and electrical cord attached and ready
to be connected. Please do not remove the high loop
connection for the drain line.
492161 Install DW Outdoor USA EN Rev 01.indd 2
2014-10-01 13:17:39
