Access Point Configuration
4-9
Figure 4-10. Wireless Operational Settings window
Under the “Setup” menu you can either enable or disable SNMP traps, which are mes-
sages displayed in the right bottom corner indicating that an action related to the AP -
Bridge took place, such as:
• Trap Reassociation: This trap message is sent when a Station’s reassociation request
is received from the AP - Bridge.
• Trap Association: Indicates the reception of an association request packet and the
sender Station's successful association with the Wireless Bridge.
• Trap Disassociation: This trap message is sent when a disassociation notification
packet is received from a Station.
• Trap Reset: This trap message is sent when the AP-Bridge resets.
• Trap Setting IP Address with Ping: This trap message is sent when the AP-Bridge IP
address is set with the transmission of a ping message.
• Trap Start Up: This trap message is sent when Bridge starts up.
• Trap Failed To Erase Flash: This trap message is sent when Bridge fails to erase
flash.
You can see additional information for every Trap Message by selecting the “View
Record” option under the “Traps” menu.
In order to “Reset Device” or “Restore Defaults” you need to select the appropriate sub-
menu under the “Commands” menu.
Summary of Contents for RTW020
