Access Point Configuration
4-11
Figure 4-12. DFU Utility Bridge Configuration window
The current parameters of the Bridge can be retrieved by pressing the “Get” button in
the Bridge Configuration dialog. You can update the bridge configuration parameters by
setting them first and then selecting the “Set” button.
Network Parameters:
• Ethernet IP Address: The IP Address of the AP
• Ethernet Subnet Mask: The Ethernet station and the Access Point must be on the
same subnet. The IP address for the Access Point must correspond to the Subnet
Mask.
• Ethernet MAC Address: The MAC address of the AP.
802.11 Parameters:
• Channel: Select the channel to be used. There are 14 channels available.
• Rate: Select the rate to be used among the following options: 1 Mbps, 2 Mbps, 5.5
Mbps, and 11 Mbps.
• ESSID: Select the ESSID to be used.
• Fragmentation Threshold: This is the option for the Fragmentation Threshold
activation.
• RTS Threshold: This is the option for the RTS Threshold activation.
Summary of Contents for RTW020
