© 2020 United States Stove Company
5
ASSEMBLY INSTRUCTIONS
NOTE: During opening and closing of the feed and
ash doors of this heater, it may seem that the fit
of the door is “too tight”. As the heater is fired, the
gasketing “settles” or “seats” itself in the door. The
tight fit at the factory and before the heater’s initial
firing is to ensure a good seal after the gasketing
“settles”.
HOW TO OPEN THE TOP LID
CAUTION! DO NOT OPEN OR CLOSE THE TOP
WHEN THE HEATER IS HOT! To open, grasp the top
at the front or on each corner and lift all the way up
until the support rod stops the motion. Then gently
lower the top allowing the support rod to settles in
the cup, holding the top open. To close, lift the top
until the support rod is out of the cup. Pull the rod
forward and lower the lid closed.
SMOKE CURTAIN INSTALLATION
1.
Open the cabinet door and the fire door.
Cabinet Door
Fire Door
2.
Locate the two hooks inside the firebox above
the fire door opening as shown.
Inside view of the fire door opening without the
smoke curtain installed.
Inside view of the fire door opening with the
smoke curtain installed.
3.
Slide the smoke curtain through the fire door
and hook into place. Note: the smoke curtain
has a bend at the bottom. When placing the
smoke curtain into place ensure the bend it
facing toward the fire door as shown.
