© 2020 United States Stove Company
17
CAUTIONS:
• ASHES COULD CONTAIN HOT EMBERS EVEN
AFTER TWO DAYS WITHOUT OPERATING
THE STOVE.
• THE ASH PAN CAN BECOME VERY HOT.
WEAR GLOVES TO PREVENT INJURY.
• NEVER BURN THE STOVE WITH THE ASH
TRAP OPEN. THIS WOULD RESULT IN OVER
FIRING THE STOVE. DAMAGE TO THE STOVE
AND EVEN HOUSE FIRE MAY RESULT.
SMOKE & CO MONITORS
Burning wood naturally produces smoke and
carbon monoxide (CO) emissions. CO is a poisonous
gas when exposed to elevated concentrations for
extended periods. While the modern combustion
systems in heaters drastically reduce the amount of
CO emitted out the chimney, exposure to the gases
in closed or confined areas can be dangerous. Make
sure your stove gaskets and chimney joints are in
good working order and sealing properly to ensure
unintended exposure. It is recommended that you
use both smoke and CO monitors in areas having
the potential to generate CO.
GASKET CARE
WARNING:
NEVER OPERATE THE STOVE WITHOUT A
GASKET OR WITH A BROKEN ONE. DAMAGE
TO THE STOVE OR EVEN HOUSE FIRE MAY
RESULT.
This unit’s door uses a 1” diameter rope gasket. It
is recommended that you change the door gasket
(which makes your stove door air tight) once a
year, in order to ensure good control over the
combustion, maximum efficiency and security.
To change the door gasket, simply remove the
damaged one. Carefully clean the available gasket
groove, apply a high temperature silicone sold for
this purpose, and install the new gasket. You may
light up your stove again approximately 24 hours
after having completed this operation.
ATTENTION:
THIS WOOD HEATER NEEDS PERIODIC
INSPECTION AND REPAIR FOR PROPER
OPERATION. IT IS AGAINST FEDERAL
REGULATIONS TO OPERATE THIS WOOD
HEATER IN A MANNER INCONSISTENT WITH
OPERATING INSTRUCTIONS IN THIS MANUAL.
For Parts Assistance Call: 800-750-2723 Ext 5051 or Email: [email protected]
The information in this owner’s manual is specific to your unit. When ordering replacement parts the
information in this manual will help to ensure the correct items are ordered. Before contacting customer
service write down the model number and the serial number of this unit. That information can be found on
the certification label attached to the back of the unit. Other information that may be needed would be the
part number and part description of the item(s) in question. Part numbers and descriptions can be found
in the “Repair Parts” section of this manual. Once this information has been gathered you can contact
customer service by phone 1-800-750-2723 Ext 5051 or Email [email protected].
Model Information
Model Number
Serial Number
HOW TO ORDER REPAIR PARTS
CHIMNEY MAINTENANCE
