ASCO 5010 Remote Display Unit
10
Section 4.
Mounting
The ASCO 5010 Remote Display Unit is designed for mounting on a flat panel through a 138x138mm cutout with two 5mm
holes. Two screws are supplied for fixing the display unit to the panel from behind. A typical location for mounting the ASCO
5010 RDU is on the front panel of an electrical distribution panel. Figure 5 and Figure 6 aid in describing the method of attaching
the RDU to a panel.
A 138 x138 hole is cut out from the panel and the RDU is slid in to place from in front. The RDU is then fixed in place using two
screws from behind.
Figure 5: Screw Holes for Affixing RDU to a Panel
Figure 6: Mounting the Remote Display Device to a Panel
