AT5000 1310 nm F3ST Optical Transmitter
Solutions Provider for FTTx, RFoG, and HFC
www.ascentcomtec.com
Page 5 of 26
Warning
Exposure to class 1M laser radiation is possible. Access should be restricted to trained
personnel only. Do not view exposed fiber or connector ends when handling optical
equipment.
Ensure adequate cooling and ventilation as specified.
The installation and operation manual should be read and understood before units are put into
use.
Always replace protective caps on optical connectors when not in use.
The typical connectors fitted are SC/APC 8°.
Note:
8° angle polished connectors must be used.
Cleaning
Use only a damp cloth for cleaning the front panel. Use a soft dry cloth to clean the top of the
unit.
Do not use spray cleaner of any kind.
Grounding
The Optical Transmitter should have good grounding with grounding resistance
＜
4
Ω
.
According to the international standard, 220V plug in adopts tri-wire rule and the middle wire
is the grounding wire.
Before connecting circuit, please use proper electric wire (#20AWG and more) to connect the
grounding screw and the grounding frame. When use DC input power supply, the equipment
chassis must be grounded.
Overloading
Overloading wall outlets and extension cords can result in a risk of fire or electric shock.
Use approved electrical cords.
Damage requiring service
Unplug unit and refer servicing only to Ascent Communication Technology qualified service
personnel.
Servicing
Do not attempt to service this unit yourself. Refer all servicing only to Ascent Communication
Technology qualified service personnel.
powered by
