20
1.5.5
NVR - Encode, Motion Detection, Camera Names, Date & Time
Some IP cameras support remove configuration of encode, motion detection, and
camera name settings from the NVR. However for the best results and accuracy of
settings, they should be set on the IP camera directly via the web client interface
as shown below.
*Note: IP camera interfaces, menus, and settings will vary based on model.
Using Internet Explorer enter the IP address of the IP camera. Login with Username:
admin Password: admin (if the Username or Password have been changed this
does not apply).
Note: You will need to install an Active X control which may require allowing
unsigned Active X controls under Trusted Sites. See section 5.1.1 Internet Browser
Setup for more information on Active X installation.
Click the “Setup” tab near the top of web page. Click on “Event” on the left side,
then click “Video Detect”. Under the “Video Detect” tab, use the settings shown in
the following picture.
