Measurement Mode
Press the "L / C" button to change from capacitance
measurement to inductance measurement and reverse. Each
press cycles between the modes.
Relative Mode (
Δ
REL)
The capacitance / inductance of the test leads or fixtures may
affect the measurements, especially with very small values.
After the test leads are connected, press the "ΔREL" button to
set the current value to zero. "REL" is shown on the display,
and the following measurements refer to this value.
The test leads should be shorted in inductance measuring mode
and open in capacitance measuring mode while pressing the
"ΔREL" button.
Press "ΔREL" again to leave the Relative Mode.
Note: in Relative Mode, negative values are possible if the
actual reading is below the recorded value. Like when you
disconnect the test leads after zeroing them out.
23
