ASBER EASY-H500, Installation And Operation Manual

Page: 47 / 184

46
asberprofessional.com
asberprofessional.com
ENGLISH
6.1.2 Switching on the machine
Before switching on the machine, check the following:
9 The mains switch must be on.
9 The water stop cock must be open.
9 There must be water in the mains network.
9
The corresponding filters must be in place.
9
The overflow should be mounted in place.
To switch on the machine, turn the selector switch from 0 to STANDBY . (See figure).
6.1.2.1 Filling and heating.
When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash
tub. The filling process may last a few minutes. Once the wash tub is full, the boiler and the tub start to
heat up. Although it is possible to start the wash process, this is not recommended as the water inside
the machine is not yet at the ideal temperature. When the machine has reached the ideal temperature
for washing the dishes properly, the amber light comes on, advising the user that the machine is
ready.
The required temperature of the machine is 85
⁰
C / 185
⁰
F in the rinse boiler and 60
⁰
C / 140
⁰
F in the
wash tub. ASBER recommends that the water in the dishwasher is changed every 40/50 washes or
twice a day.
The hood must be closed for the machine to start filling. For safety
reasons, if the hood is open, the machine will not fill.
MACHINE OFF
DRAINAGE CYCLE
(Only in EASY ‐ H500 B model)
STANDBY
55 S CYCLE
75 S CYCLE
CONTINUOUS CY ‐
CLE
Figure 9 EASY ‐ H500 HP control button
120 S CYCLE