Asahi/America 94 Series, Installation, Operation And Maintenance Manual

Page: 5 / 34

ASAHI/AMERICA, INC 655 ANDOVER STREET LAWRENCE, MA. 01843 TELEPHONE 800-343-3618
File: assembly/manuals/Series 94 Gen II A/C Modulating Svc Manual Rev. A 11/19/19
Page 5 of 27
Installation
Electrical
Reference Drawing #297QM
1. To gain access to terminal strip (Part #8 & 9) it is necessary to remove
manual override handle (Part #34) by loosening slotted setscrew (Part #35).
Remove 8 cover screws and cover.
2. Make electrical connections to terminal strip as shown on wiring schematic
located inside the cover (per various electrical codes there is a green screw
on the actuator base plate for grounding purposes). All units are completely
calibrated prior to shipment, and no internal adjustments should be required.
3. Install 1/2" NPT conduit fitting(s) to actuator base. Please ensure that proper
conduit fitting is used to maintain NEMA 4X enclosure rating.
NOTE: We recommend sealing conduit openings on units installed outdoors or
exposed to large temperature swings (15ºF or more).
We also recommend the heater and thermostat option in these applications.
4. Replace actuator (gasket if removed) cover, and install 8 cap screws supplied
and tighten securely. For outdoor or wet locations it is recommended prior to
replacing the cover that the top shaft seal be cleaned and coated with silicone
grease. Also clean shaft and lightly coat seal area of shaft with silicone
grease. Unit is now ready for operation.
120 Vac 220 Vac 12 Vdc 24 Vdc 24 Vac Cycle
Time per
90
Degrees
(Seconds)
Weight
(lbs)
Model
Torque
(in/lbs) Amp
Draw
Duty
Cycle
Amp
Draw
Duty
Cycle
Amp
Draw
Duty
Cycle
Amp
Draw
Duty
Cycle
Amp
Draw
Duty
Cycle
A94 150 0.5 100% 0.4 100% 2.0 75% 4.0 75% 4.0 75% 5 3.5
B94 300 0.8 75% 0.6 75% 2.0 75% 4.0 75% 4.0 75% 5 3.5
Note:
Amp rating is considered locked rotor
Duty cycles are for ambient temperature (73º F)