BEAVER 8･8F
14
3. OPERATION
1) Replacement the Saw Blade
-Be sure to unplug the unit from power supply before changing the blade.
-When a new saw blade is used, test cuts are required as it is liable to cut obliquely.
[Spring model]
Cut a workpiece once or twice at the cutting
load position “ L”.
[Hydraulic model]
First few workpieces should be cut at about a half the ordinary cutting speed.
-Install the saw blade after completely wiping oil and dirt off.
-Use the genuine ASADA Band Saw Blade.
-
Band Saw Blade is sharp, so don’t hand with bare hands.
(1)
Remove the
Back-Plate Stopper
to take off the Back Plate. <Fig.1>
(2)
Turn the Tension Handle to
“
RELEASE
”
direction. <Fig.2>
(3) Slide the Blade Guide F forward. <Fig.3>
(4)
Fix new saw blade into the Blade Guide carefully on both sides.
(5)
Place saw blade on Pulley and hold saw blade in Blade Guide.
*For easy setting, catch saw blade with the Saw Blade Receiving Washer.
(6)
Turn the Tension Handle to
“
TENSION
”
direction.
*Before turning on switch make sure saw blade is on Pulley.
<Fig.1>
<Fig.2>
<Fig.3>
Back-Plate
Back-Plate
Stopper
Tension
Handle
TENSION
RELEASE
Saw Blade
Receiving
Washer
Pulley
Blade Guide F
Summary of Contents for BEAVER 8
Page 26: ...BEAVER 8 8F 25 ...
Page 27: ...BEAVER 8 8F 26 ...
