Safety Warnings
Power Supply
40
www.arwestcom.com
C.2. Power Supply
Connect the supplied adapter to the side of the unit in the slot. Plug the two-prong end of the power cord
to an AC100-240V outlet. If you have difficulty inserting the plug, turn it over and reinsert it. If the unit
will not the used for a long time, disconnect the plug from the outlet.
Note:
Before plugging the power cord into an AC outlet, make sure that all the connections have been made.
C
AUTION
:
To reduce the risk of electric shock, do not perform any servicing other than that contained in the
operating instructions unless you are qualified to do so.
C
AUTION
:
To avoid the introduction of hazards when operating and installing, before connecting of the equip-
ment to the supply, make sure that the supply meets local and national safety ordinances and
matches the equipment’s voltage and current requirements.
C
AUTION
:
Never attempt any maintenance or cleaning of the supply while plugged in. Always remove supply
from AC power before attempting service or cleaning.
Warning:
If the voltage supplied is below the minimum specification, the adapter will suspend operation. If the voltage
supplied is above the maximum specification, the adapter may be permanently damaged, voiding your
warranty.
Make sure cords are located so that will not be stepped on, tripped over, or otherwise subjected to damage
or stress. Do not operate equipment with a damaged cord or plug – replace immediately. To reduce the
risk of damage to the equipment, pull by the plug body rather than the output cord when disconnecting
the equipment.
Do not operate the supply if it has received a sharp blow, been dropped, or otherwise damaged. Do not
disassemble the supply.
Warning:
Before connecting the external power source and the adapter, make sure that the power source matches the
adapter’s voltage and current requirements.
C.3. Usage Warnings
If this product has been dropped, altered, transported or shipped without proper packaging, or otherwise
treated without care, erroneous measurements may occur.
Note:
Do not connect or disconnect equipment with wet hands, you are at risk of electric shock if you do!
Inform ArWest immediately if this product does not function properly. Only allow authorized ArWest
warranty service centers to service or repair this product.
Warning:
To avoid the equipment serious damage, do not switch the modem to transmit mode if RF antenna is not
connected.
C
AUTION
:
Never attempt connecting/disconnecting the serial cable while supply is plugged in. Always remove
supply from AC power before connecting/disconnecting serial cable.
Summary of Contents for alphawave AW400
Page 2: ...www arwestcom com...