Configuration
Connecting AW400 and Computer
Power supply requirements
17
www.arwestcom.com
2.4. Connecting AW400 and Computer
In order to interface an AW400 to a third party system ArWest have developed an ‘open-ended’
transparent cable. The user can connect whatever connector is required to the ‘open-end’ of the cable
following the correct pin protocol for this cable (CM-10001).
To configure, or maintain AW400, you need to connect the modem and a computer using cable Accessory
Data-Ser-Pwr Cable, DB9/DB15/SAE (p/n CM-00215t.)
Figure 2-2. Cable CM-00215
1. Connect the serial port of the computer or USB-to-Serial adapter to the serial port of the modem
at the switched off power supply by using of a cable.
2. Turn on your computer.
3. Power AW400.
Once you have established a connection between the modem and the computer, you will be able to:
• Configure the modem and its components
• Send commands to the modem
• Use AWLaunch to load new firmware to the modem
Summary of Contents for alphawave AW400
Page 2: ...www arwestcom com...