ArWest alphawave AW400, User Manual, Page: 20 / 44

Configuration
Configuring AW400
Power supply requirements
20 www.arwestcom.com
5. Once the connection is established in the Configurations tab Identification subtab the unit’s infor-
mation will appear (Figure 2-5), i.e. unit serial number, firmware, hardware and boot loader ver-
sions:
Figure 2-5. Identification tab
• In the Unit Name text field the unit’s name can be inserted;
• In the Owner field the owner’s name can be inserted.
To save the changes click Save Config. button.
6. In the Configurations tab, Wireless subtab, set the following parameters (Table 2-1) and click
Identify (Figure 2-6 on page 21). To save the changes click Save Config. button.
Table 2-1. Modem Parameters for the Wireless Subtab
Parameter Base Modem Remote Modem Repeater
Protocol Base
Select from the List Simplex
Transmitter, Half Duplex, or
PCC transmitter if Pacific crest
protocol is used. Remote
Select from the List Simplex
Receiver, Half Duplex Remote,
or PCC Receiver if Pacific crest
protocol is used. Remote
Select from the List Repeater,
if the modem will be used as
Repeater, or PCC Repeater, if
Pacific crest protocol is used.
Modulation type
Specifies a modulation scheme that will be used by your modem
1
. DQPSK is recommended.
Forward Error
Correction (FEC) Enable
Scrambling Enable Enable
RF power Select the transmission power for the radio modem in the RF modem slider, or type the value in
the edit box
1. For both Base and Remote modems the modulation type must be the same.